KeeGuard® Fall Protection Certifications
KeeGuard® Contractor Fall Protection Certifications

KeeGuard Permanent Fall Protection, KeeGuard Contractor Temporary Fall Protection, and the
KeeGuard Skylight Railing have been independently tested and meet or exceed all relevant
North American and International Safety Requirements.
 

OSHA Standard 29 CFR 1910.23 (e) (1), 29 CFR 1910.23 (e) (3) (iv)

OSHA Standard 29 CFR 1926.502 (b) (1), 29 CFR 1926.502 (b) (14)

International Building Codes

British Columbia - National Building Code
Sections 4.1.10.1(e), 4.1.10.1(2) and 4.1.10.1(4)

Manitoba - National Building Code
Sections 4.1.10.1(e), 4.1.10.1(2) and 4.1.10.1(4)

Newfoundland & Labrador - National Building Code
Sections 4.1.10.1(e), 4.1.10.1(2) and 4.1.10.1(4)

Nova Scotia - National Building Code
Sections 4.1.10.1(e), 4.1.10.1(2) and 4.1.10.1(4)

Ontario - Ontario Building Code
Sections 4.1.10.1(1)(b), 4.1.10.1(2) and 4.1.10.1(4)

Saskatchewan - National Building Code
Sections 4.1.10.1(e), 4.1.10.1(2) and 4.1.10.1(4)

Download KeeGuard Certifications:

TÜV Certificate (PDF 128k) TÜV has tested KeeGuard to ensure compliance with the requirements of
OSHA Standard 29 CFR 1910.23, HSE S.R. No. 15:1983, BGV A1: 2000, BGR 184 (ZH 1/584):1985,
BGG 928 (ZH 1/586):1984 and NF E85-003\EN ISO 14122.3:2001.

Quality Inspection Services - KeeGuard Fall Protection Railing System
Test of 200 lbs top rail pressure (jpeg image)

Quality Inspection Services - KeeGuard Contractor Fall Protection Railing System
Test of 200 lbs top rail force (jpeg image)

Quality Inspection Services - KeeGuard Skylight Fall Protection Railing
Test of 200 lbs top rail load (jpeg image)

Quality Inspection Services - KeeGuard Fall Protection Railing System
Test for lbs per linear foot loads (PDF 644k)

Quality Inspection Services - KeeGuard Fall Protection Railing System with CB3's
Test for lbs per linear foot loads (PDF 636k)

Quality Inspection Services - KeeGuard Contractor Fall Protection Railing System Test for lbs per linear foot loads and point load (PDF 540k)

Hite Engineering Corp. - Ontario, Canada (jpg image)

User Information:
All set screws should be tightened to the recommended 29 ft/lbs or 39 Nm during installation of the system.
It is recommended that periodic inspections are performed to ensure system integrity.

Additional Resources:

OSHA sets the standards for workplace safety and health. Visit the OSHA website.

TÜV Product Service provides a full range of compliance services including testing, consultancy, and international compliance management.

Testing to industry standards and regulations - Quality Inspection Services, Inc. website